Heating & cooling · Kansas City metro
HVAC installation & replacement in Kansas City, with geothermal at the center.
GeothermalKC is a licensed heating & cooling contractor for homes & new buildings: geothermal first, & conventional or air source systems where they suit the building better. Installing both means the consultation compares them side by side for the same building.
One contractor for geothermal & conventional systems
Installing geothermal heat pumps & the conventional systems around them means the recommendation follows the building, the site & the budget rather than one product line. When geothermal is not the better choice for a building, the consultation says so.
Heating, cooling & plumbing work is contracted & licensed through GeothermalKC, & permits are pulled where the city or county requires them. Electrical requirements & responsibilities are defined in the project proposal.
HVAC & plumbing work is contracted & licensed through GeothermalKC, for homes & new buildings across the Kansas City metro & surrounding counties.
Heating & cooling work GeothermalKC handles
- Geothermal heat pumps, new or replacing an older system
- Furnace, air conditioner & heat pump replacement & retrofits
- Heating & cooling for new construction, planned with the builder
- Duct supply & return modifications
- Ductless mini splits for garages, shops, conversions & detached spaces
- Thermostats & controls
- Air quality equipment, including humidifiers
- Boiler installation & boiler retrofits, including radiant floor heat
What comes next
Geothermal & new buildings
Geothermal is the system GeothermalKC builds around, & new buildings are the easiest time to plan heating, cooling & hot water together.
Request ConsultationHow a heating & cooling project runs
Consultation request
The current system type & age, the building & photos of the equipment help.
Site evaluation
Equipment, ductwork or piping, electrical service & the building are checked.
Options & proposal
The systems that suit the building are compared, with a written scope & price.
Installation
Equipment, connections, ductwork or piping & controls go in.
Start up & walkthrough
The system is started, checked & explained.
Typical projects & exclusions
Typical projects
- Homes replacing aging heating & cooling equipment
- New homes, barndominiums & shops planned with the builder
- Garages, additions & detached spaces without ductwork
Not included
- Commercial systems that need a stamped mechanical design, until the design is in hand
- Building & remodeling work, which All Under One Roof handles
Common questions
Does GeothermalKC install conventional HVAC as well as geothermal?
Yes. Furnaces, air conditioners, air source heat pumps & mini splits are installed alongside geothermal, so the consultation can recommend the system that suits the building.
Is GeothermalKC licensed for HVAC work?
Yes. Heating, cooling & plumbing work is contracted & licensed through GeothermalKC, & permits are pulled where the city or county requires them.
What areas does GeothermalKC serve for heating & cooling?
Heating & cooling work covers the Kansas City metro & surrounding counties in Kansas & Missouri. Geothermal reaches further, across the region from Topeka to Sedalia.
Geothermal or a conventional system?
Geothermal has no outdoor unit, steady efficiency in the coldest & hottest weather & a ground loop that outlasts the equipment, at a higher installed cost & with room needed for a loop. An air source heat pump or a furnace & air conditioner costs less to install. The consultation compares the options for the building, the site & the budget.
Does GeothermalKC repair HVAC systems?
GeothermalKC focuses on installation, replacement & retrofits. Repair requests are reviewed case by case at the consultation.
Related heating, cooling & plumbing services
Project consultations
Request a Consultation
HVAC services across the Kansas City metro & surrounding counties. Consultation requests with the location & photos of the site are the quickest to schedule.